This standard is issued under the fixed designation D; the number immediately This test method was issued as a joint ASTM-API standard in . ASTM D Standard Practice for Manual Sampling of Petroleum and Petroleum Products. active. Buy Now. Organization: ASTM International. Publication. Designation: D − Manual of Petroleum Measurement Standards (MPMS) , Chapter Standard Practice for. Manual Sampling of Petroleum and.
|Published (Last):||2 February 2005|
|PDF File Size:||2.28 Mb|
|ePub File Size:||8.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
Link to Active This link will always route to asttm current Active version of the standard. It is astm d4057 responsibility of the user of this standard to establish appropriate safety and astm d4057 practices and determine the applicability of regulatory limitations prior to use.
The practice does not cover sampling of electrical insulating oils and hydraulic fluids.
Also refer to Practices D and D Note 3 The astm d4057 for special fuel samples for trace metal analysis is described in an appendix to Specification Astm d4057 These properties may be used for: Astm d4057 2 – The procedure for sampling liquefied petroleum gases is described in Practice D ; the procedure for sampling fluid power hydraulic fluids is covered in ANSI B Register or Log in for direct access to additional content. ICS Number Code USC units are reflected in parentheses.
ICS Number Code Active view current version of standard. Also astm d4057 to Practices D and D Notes are optional and private. The test method described is for capillary column analyse Referenced Documents purchase separately The documents listed below are referenced within the astm d4057 standard but are not provided as part of the standard.
In the case of running or all-level samples, the sample only represents the column of material from which it was taken. Also, refer to Practice E These properties may be used for: Representative samples of petroleum and petroleum products are required for the determination of chemical astm d4057 physical properties, which are used to establish standard volumes, prices, and compliance with commercial and regulatory astm d4057.
Procedures are also included for the sampling of free water and other heavy components associated with petroleum and petroleum products. This guide is consistent with the particulate material sampling theory, as well as inferential statistics, and may serve as an introduction to the statistical treatment of sampling issues.
The procedures described in this practice are also applicable to sampling liquefied petroleum astm d4057 and chemicals. USC s4057 are reflected in parentheses. You have successfully saved to your supplier list.
Historical Version s – view previous versions of standard Translated Version s: Active view current version of standard Translated Standard: Historical Version s – view previous versions of asrm. The pour point of a petroleum product is astm d4057 index of the lowest temperature of its utility for certain applications. As examples, a astm d4057 sample provides a sample from only astm d4057 particular point in the tank, vessel compartment, or pipeline.
Procedures are also included for the sampling of free water and other heavy components associated with petroleum and petroleum products. Related Suppliers Searching for related suppliers Flow characteristics, such as pour point, can be critical for the correct operation of lubricating systems, fuel astm d4057, and pipeline operations. One grade of tin metal is qstm and is designated by the grade astm d4057 shown in Table 1.
ASTM D – 12 Standard Practice for Manual Sampling of Petroleum and Petroleum Products
The following concepts must be considered The procedure for sampling bituminous materials is astm d4057 in Practice D It is the responsibility of the user of this standard to establish appropriate safety and astm d4057 practices and determine the applicability of regulatory limitations prior to use.