Buy ASTM D Standard Practice for Manual Sampling of Petroleum and Petroleum Products from SAI Global. Designation: D − Manual of Petroleum Measurement Standards (MPMS) , Chapter Standard Practice for. Manual Sampling of Petroleum and. This standard is issued under the fixed designation D ; the number immediately following This method was issued as a joint ASTM-API standard in
|Published (Last):||6 February 2014|
|PDF File Size:||18.6 Mb|
|ePub File Size:||20.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
Seta Sampling Tube for ASTM D, ASTM D, IP 51
The procedure for sampling bituminous materials is described in Practice D The procedure for special fuel samples for trace metal analysis is described in an appendix to Specification D As examples, a spot sample provides a sample from only one particular point in the tank, vessel compartment, or pipeline. Practice D provides guidance on sample containers and preparation for sampling aviation fuel.
Note 3 The procedure for special fuel samples for trace metal analysis is described in an appendix to Specification D USC units are reflected in parentheses. Asttm view current version of standard Translated Standard: Link to Active This link will always route to the current Active version of the standard.
Active view current version of standard. Historical Version s – view previous versions of standard Translated Version s: Referenced Wstm purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ICS Number Code The practice does not cover sampling of electrical insulating oils and hydraulic fluids. Procedures are also included for the sampling of free water and other heavy components associated with petroleum and petroleum products. Also refer to Practices D and D Also, refer to Practice E Referenced Documents purchase separately The documents listed below are referenced r4057 the subject standard but are not provided as part of the standard.
ICS Number Code Historical Version s – view previous versions of standard. Note 1 – The procedures described in this practice may also be asttm in sampling most noncorrosive liquid industrial chemicals, provided that all safety precautions specific to these chemicals are strictly followed.
These properties may be used for: In the case of running or all-level samples, the sample only represents the column of material from which it was taken.
Link to Active This link will always route to the current Active version of the standard. Note 2 – The procedure for sampling liquefied petroleum gases is described in Practice D ; the procedure for sampling fluid power hydraulic fluids is covered in ANSI B It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
A summary of the manual sampling procedures and their applications is presented in Table 1. The procedures described in d057 practice are also applicable to sampling liquefied petroleum gases and chemicals.